This article describes what to do in case Pod Setup procedure is not improving the Print Quality, see the following image as an example:
Before Advanced Pod Setup
Required Outcome:
Before you start the process please make sure the pod is clean & undamaged:
-
- Make sure the pod is not damaged: be very gentle when installing and removing the cartridge. Rough installation causes this damage.
- Make sure the bottom of the pod is not clogged:
-
On the side menu, tap "Advanced":
Follow the on-screen tutorial, make sure:
-
Use an empty cup
-
The Ripple Maker tray will go up and down 3 times.
-
After the Advanced Pod Setup finishes, the Ripple Maker instructs you to perform the Pod Setup process one more time.
-
If the Pod Setup results are not as the required, please run Advanced Pod Setup 1 more time.
-
Replace the pod:
Tap "Replace Pod" and follow the steps:
If you need any further assistance please contact Ripples' support- Support@Drinkripples.com or call your local support number.
Comments
0 comments
Please sign in to leave a comment.