This article describes how to Set up the Ripple Maker for 1st use
-
Place the Ripple Maker in accordance with safety instructions in the manual.
-
Install close to an electrical outlet.
-
Place the Ripple Maker on a level surface.
-
Position the Ripple Maker in a convenient location for the barista. Keep in mind the work flow of the barista and other employees.
-
Make sure there is a good Wi-Fi signal or an Ethernet jack close by.
-
Connect the power cord to the power input located at the back of the Ripple Maker. Plug the other end into the wall outlet. Follow safety instructions regarding the AC connection.
-
Unbox the Wi-Fi dongle and insert it into the USB port at the bottom of the Ripple Maker or connect an Ethernet cable to the Ripple Maker.
-
Switch on the Ripple Maker by pressing the On/Off button at the base of the Ripple Maker and wait for the system to boot up.
-
Select your Wi-Fi connection.
-
Please wait while the Ripple Maker is being registered.
-
Confirm your location and ownership.
-
The User Agreement is displayed on screen, Please accept the agreement.
-
Tap the “START” button and start using the Ripple Maker.
Comments
0 comments
Please sign in to leave a comment.