Tal Shulman

This article is for designers who will create a frame using design software. For customers who do not wish to use design software please refer to this article- The Ripples Cloud Frame Builder    Ch...

BLUE SCREEN - The source cable (HDMI) on the LCD screen is disconnected or partially connected.Check the troubleshooting video attached.Symptom:The screen is blue/black.Action:1. Turn off the Rippl...

  Symptom: Image printed not in center     Actions: Check the Mat is facing you properly Check that the cup in the middle of the mat Perform Daily maintenance [reset the pod house homing] Check...

Tutorial: How to Implement an Empty Frame (Watermark)An empty frame, often referred to as a "blank frame," is essential if you wish to allow custom images or selfies to be printed without a frame. ...

    No Pod Detected Cause: No pod inside   No Cup Cause: No Cup detected If the there is a cup + tray lifts --> Foam sensor blindness symptom Action: update to latest SW version put the Opaqu...

This article describes how to find your Ripple Maker's serial number.Ripple Maker II1) Taping the 3 stripes on the top left side (menu):Click on the "i" (Info) icon The serial number will appear on...

Did you forget your Ripples Cloud Password? No worries, just go through the steps below and you will be just fine.1. On the Ripples Cloud Login page https://my.drinkripples.com/ripples, click on “...

How to create or change your Ripple Maker location in the Ripples Cloud? Create a new Location:1. Login to our cloud at https://my.drinkripples.com/ripples 2. Click on the Location tab under the As...

Find our cloud tutorial now in German!