Guy B

The most important part of Daily Maintenance is to clean the drip tray.If too much extract builds up it can clog the pod resulting in poor quality Ripples.  Take out the Drip Tray from the left-han...

Please do the following steps before you close the Ripple Maker for more than a day:   Ripple Maker AM/PM Clean the Ripple Maker; use only cloth and hot water Clean under the tray -  Use “Raise Tr...

  Symptom: Image printed not in center     Actions: Check the Mat is facing you properly Check that the cup in the middle of the mat Perform Daily maintenance [reset the pod house homing] Check...

    No Pod Detected Cause: No pod inside   No Cup Cause: No Cup detected If the there is a cup + tray lifts --> Foam sensor blindness symptom Action: update to latest SW version put the Opaqu...

This article  describes how to solve P-255 Error Symptoms:Actions:1. Open the Menu --> Advanced ---> click on "Clear Printer Setup"  

How to Pod Setup in Ripple Maker Original - procedure is not improving the Print Quality, see the following image as an example:  Before Advanced Pod SetupRequired Outcome: Before you start the pro...

Action: 1. On the side menu tap "Advanced":  2. Tap "Language":  3. Choose the required Language. 4. Go back to the home screen by taping the "back" icon - . 

Did you forget your Ripples Cloud Password? No worries, just go through the steps below and you will be just fine.1. On the Ripples Cloud Login page https://my.drinkripples.com/ripples, click on “...

This article describes how to Set up the Ripple Maker for 1st usePlace the Ripple Maker in accordance with safety instructions in the manual.Install close to an electrical outlet.Place the Ripple M...