This article will discuss how to troubleshoot when your Ripple Maker is not printing and producing an Error 3.
Pod not found 
1. Remove the pod from the Ripple Maker (using "replace pod" wizard)
2. Move your finger on the golden pins- Make sure they're all pops out and clean:
3. Make sure the pod holder (black part) didn't come apart:
How to re-connect the pod holder (black part):
4.Before you enter the pod, make sure you've removed the Blue Tape from the Pod
5. Make sure the print card is not damaged / dirty:
If it is, please turn off the Ripple Maker and clean it gently with a dry paper towel.
5. Turn off and back on:
Press the power button until the white light turns off.
If the problem persists please contact Ripples' support- Support@Drinkripples.com or call your local support number.